![]() ![]() ![]() Stuff about mechanical work or hydraulics is not in my wheelhouse.įor example, what tool would you use to find the backllash? vernier calipers? dial gauge? I didn't even know what the heck backlash is exactly until after I took the test. I study a lot of electrical, PLC programming, and electronics/solid state/pcb's. They allow 3 hrs to do a test that normally takes 1-1.5hrs. This was for a recruiter that places people in major distribution centers such as barnes&noble or amazon. Whats an overload, and tricky wording bs I didn't appreciate. IME 3010 Installation Guide Commerce-Industry. The rest were mostly about electrical in industrial. study in which they will spend one trimester (432 hours) per elective. Probably 30 q's were about non electrical stuff. Thankyou, Ive been reading up on the uglys electrical references guide book and I did not know they had. There are MST KNets You can get access to that help prep for the test, which is a major help. ![]() I was a T1 with safety and had access to a Kindle. It had a lot of mechanical and hydraulic q's. Get familiar with ohms law and schematic symbols AC/DC, etc. The second one I've taken was a bit easier with 100 q's, with an average score of 50-60%. This was for a surface mine/ aggregate mine electrician job. It had an average score of ~20% I couldn't use a calc. The first one I took was much harder than the second, it had 80 q's and had questions like op-amp configs, electrical theory, and converting number systems (octal, decimal, hex). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |